BEA-646
460 Watt
- High-quality electrolyte capacitors (+105 °C)
- Ball-bearing fan with tacho signal
- Designed for continuous operation 24/7
The 460 W PC power supply BEA-646 is distinguished by very high reliability, robustness and long service life. Designed for continuous operation (24/7) its MTBF is 87 000 h at +50 °C operating temperature. The regulated ball-bearing fan provides a tacho signal and can continuously be monitored by the board, which is very important with regard to system reliability.
| Technical data |
|
|---|---|
| Input voltage |
90…264 VAC, active PFC |
| Input frequency |
47…63 Hz |
| Input current |
7.5 A (115 VAC) / 3.5 A (230 VAC) |
| Inrush current |
65 A (115 VAC) / 125 A (220 VAC) |
| Efficiency |
>70 %, 115 / 230 VAC (full load) |
| Hold up time |
>16 ms |
| Power-Good-Signal |
Switch on delay 100…500 ms |
| Protection |
Short circuit protection: At each output, switch off / +5 Vsb, auto-recovery |
| Isolation voltage |
Input / Chassis 3000 VAC |
| Earth leakage current |
<3.5 mA, 250 VAC |
| Safety / EMC |
TÜV, UL, CE |
| Operating temperature |
0…+55 °C |
| Derating |
From 90…100 VAC to 435 W at +40 °C and 410 W at +50 °C |
| MTBF |
87 000 h at +50 °C, without fan |
| Storage temperature |
-20…+80 °C |
| Operating humidity |
10…90 % RH, non-condensing |
| Dimensions (WxDxH) |
150 x 140 x 86 mm ±0.5 mm |
| Weight (net) |
1.95 kg |
|
Article |
Output |
Output current |
Output current |
Load |
Ripple & |
|---|---|---|---|---|---|
| BEA-646 |
+3.3 V |
0.5 A |
30 A |
±5 % |
60 mV |
| +5 V |
1.5 A |
40 A |
±5 % |
60 mV |
|
| +12 V |
1 A |
32 A |
±5 % |
100 mV |
|
| -12 V |
0 A |
1 A |
±5 % |
100 mV |
|
| -5 V |
0 A |
0.8 A |
±5 % |
100 mV |
|
| +5 Vsb |
0 A |
2 A |
±5 % |
60 mV |
During a cross regulation test we recommend to keep the channel with higher output load at 90 % of its max. power and the channel with lower output load at 20 % of its max. power. Ripple and Noise was measured by a 20 MHz bandwidth limited oscilloscope with connected 220 µF electrolytic capacitor and 0.1 µF ceramic capacitor at each output.
As a power component this PSU is for assembly purposes only and must not be operated in unassembled condition. The final assembly has to comply with the valid EMC and safety standards.
