UPSI-1202
12 VDC/6 A
- Continuous battery monitoring
- Timer function
- PC interface
The newly designed DC UPS UPSI-1202 protects connected consumer loads from supply voltage fluctuations and interruptions. The μC controlled DC UPS provides various protections. Among the most important is the continuous battery monitoring feature. This ensures that sufficient capacitance remains in the battery to guarantee the supply of consumer loads in case of power failure. New features of the UPSI-2401 are a load sensor and a timer function. The timer function was integrated and allows a timer-controlled switch-off of the UPS.
| Technical data |
|
|---|---|
| Input voltage |
12 VDC (10.6…16 V) |
| Input current |
6.6 A max. |
| Output voltage |
In normal mode: app. 0.65 V max. below input voltage |
| Output current |
6 A max. |
| Battery charge current |
0.6 A max. (interneral battery charger) |
| Charging method |
UI characteristic, with temperature regulation |
| Protection |
Deep discharge protection: 9.7 VDC ±2 % |
| Transfer time / limits |
Mains / Battery 9.7 VDC ±2 %, Battery / Mains 10.6 VDC ±2 % |
| Interface |
DSUB9 connector, female Outputs: Power Fail, Battery Low / Input: Shutdown |
| Type of battery |
Lead-gel-battery, maintenance-free, 2x 6 V / 3.0 Ah (recommended) |
| Safety / EMC |
CE |
| Operating temperature |
-20…+60 °C |
| Storage temperature |
-40…+80 °C |
| Storage humidity |
0…95 % RH, non-condensing |
| Dimensions |
100 x 120 x 24.7 mm ±0.5 mm |
| Weight (net) |
0.25 kg |
| Product-specific data |
|---|
| LED display |
3-colour-LED for „Power ok” (green), „Power Fail” (orange), „Battery low” (red/orange flashing) and „Battery defect” (red/green flashing), short circuit at aoutput (red) |
| Battery monitoring |
Battery test is carried out in normal mode approx every 10 minutes, in case of “Battery defect“ notification the LED flashes red/green (optional sginaling contact) |
| Power consumption |
App. 100 mA |
| Shutdown |
During system start-up the shutdown signal is suppressed for app. 2 minutes |
| Reboot function |
If power fails and then returns during the shutdown mode of Windows®, the operating system will ‚lock‘ with the message „Your PC is now safe“. The reboot function restarts the system after about 5 seconds. |
| Load sensor |
Switch off in UPS mode <10 Watt |
| Timer function |
2 min – 6 min – 20 min – off, adjustable via DIP switch |
| Back up time |
App. 60 min. at 1.7 A, app. 25 min. at 3 A, app. 8 min. at 6 A (measured at +20 °C) |
| Optional accessories | ||
Article-No. |
Designation |
|
|---|---|---|
| RUPS 2000-B1 | UPS Management Software (CD-ROM) | link to the product |
| CB-RS-020 | Interface cable, 9-pole | link to the product |
| LC-R063R4PG | Maintenance-free lead battery, 6 A/3.4 Ah (2 peaces needed) | link to the product |
| BP-0625 | CYCLON battery pack, 6 V/2.5 Ah, -30…+70 °C (2 peaces needed) | link to the product |
