MPSM-5600V
600 Watt
- Ideal for medical image processing
- Complies with IEC/EN60601-1 – 3rd Edition
- High efficiency up to 85 %
The new PC power supply MPSM-5600V is designed for medical applications. At 600 watts output it is ideally suited for image processing systems equipped with a powerful graphics card. Its modern switching design is dimensioned for maximum energy savings. Even in partial tipping operation its efficiency will not drop below 82 %. High-quality parts ensure long availability of the powered system.
| Technical data |
|
|---|---|
| Input voltage |
90…264 VAC, active PFC |
| Input frequency |
47…63 Hz |
| Input current |
10 A (115 VAC) / 5 A (230 VAC) |
| Inrush current |
20 A (115 VAC) / 40 A (230 VAC) |
| Efficiency |
82…85 % |
| Standby consumption |
<1,6 W |
| Hold up time |
>16 msec |
| Power-Good-Signal |
Switch on delay 100…500 msec |
| Protection |
Short circuit protection: At each output, switch off / +5 Vsb, auto-recovery |
| Insultaion voltage |
Input / chassis 3100 VDC |
| Earth leakage current |
<300 µA, 115 VAC/230 VAC |
| Safety / EMC |
TÜV (IEC/EN60601-1 3rd Edition), UL (UL60601-1), CAN/CSA C22.2 No. 601.1-M90, CE |
| Operating temperature |
0…+40 °C |
| Storage temperature |
-40…+80 °C |
| Operating humidity |
20…80 % RH, non-condensing |
| Dimensions (WxDxH) |
150 x 160 x 86 mm ±0.5 mm |
| Weight (net) |
2.4 kg |
|
Article |
Output |
Output current |
Output current |
Load |
Ripple & |
|---|---|---|---|---|---|
| MPSM-5600V |
+3.3 V |
0.5 A |
25 A |
±5 % |
50 mV |
| +5 V |
0.5 A |
25 A |
±5 % |
50 mV |
|
| +12 V |
2 A |
45 A |
±5 % |
120 mV |
|
| -12 V |
0 A |
0.8 A |
±5 % |
150 mV |
|
| +5 Vsb |
0.1 A |
3.5 A |
±5 % |
50 mV |
Max. output power is 600 W, combined output power at +3.3 V and +5 V must not exceed 40 A. Ripple and Noise was measured by a 20 MHz bandwidth limited oscilloscope with connected 220 µF electrolytic capacitor and 0.1 µF ceramic capacitor at each output.During a cross regulation test we recommend to keep the channel with higher output load at 80 % of its max. power and the channel with lower output load at 20 % of its max. power.
As a power component this PSU is for assembly purposes only and must not be operated in unassembled condition. The final assembly has to comply with the valid EMC and safety standards.
