BEA-640-B5
400 Watt
- Improved vibration protection according to EN 60945
- Conductor plate with coating
- Safety clip for power cord
The power supply BEA-640-B5 has been optimized for use in maritime navigation and radio communication devices according to EN 60945:2002. The robust power supply is designed for uninterrupted operation (24/7) and is built using only high quality components. The power cord is secured by means of a safety clip. Fan monitoring is ensured via a reliable tachometric signal.
| Technical data |
|
|---|---|
| Input voltage |
90…264 VAC, 120…380 VDC, active PFC |
| Input frequency |
47…63 Hz |
| Input current |
7 A (115 VAC) / 3.5 A (230 VAC) |
| Inrush current |
49 A (115 VAC) / 94 A (264 VAC) |
| Efficiency |
≥75 %, 230 VAC / ≥70 %, 115 VAC (full load) |
| Hold up time |
>16 ms |
| Power-Good-Signal |
Switch on delay 100…500 ms |
| Protection |
Short circuit protection: At every output, switch off / +5 Vsb, auto-recovery |
| Insulation voltage |
Input / Chassis 3100 VDC |
| Earth leakage current |
<3.5 mA, 115 VAC / 230 VAC |
| Operating temperature |
-10…+70 °C |
| Derating |
+50…+70 °C, 1 % / °C |
| MTBF |
100 000 h at 50 °C, without fan |
| Storage temperature |
-20…+80 °C |
| Operating humidity |
10…90 % RH, non-condensing |
| Dimensions (WxDxH) |
150 x 140 x 86 mm ±0.5 mm |
| Weight (net) |
2.1 kg |
|
Article |
Output |
Output current |
Output current |
Load |
Ripple & |
|---|---|---|---|---|---|
| BEA-640-B5 |
+3.3 V |
0 A |
28 A |
±5 % |
50 mV |
| +5 V |
0.5 A |
35 A |
±5 % |
50 mV |
|
| +12 V |
1 A |
30 A |
+7/-5 % |
120 mV |
|
| -12 V |
0 A |
0.8 A |
±5 % |
150 mV |
|
| -5 V |
0 A |
0.5 A |
±5 % |
150 mV |
|
| +5 Vsb |
0 A |
2 A |
±5 % |
50 mV |
Max. output is 400 W, combined max. output current at +3.3 V and +5 V must not exceed 45 A. Ripple and Noise was measured by a 20 MHz bandwidth limited oscilloscope with connected 220 µF electrolytic capacitor and 0.1 µF ceramic capacitor at each output. During a cross regulation test we recommend to keep the channel with higher output load at 80 % of its max. power and the channel with lower output load at 20 % of its max. power.
As a power component this PSU is for assembly purposes only and must not be operated in unassembled condition. The final assembly has to comply with the valid EMC and safety standards.
